Advanced Structural Steel Design In Oil And Gas
-
COURSE DATES AND LOCATIONS
DATE
Duration
LOCATION
FEES
Book Now
-
INTRODUCTION
Steel is perhaps the most used construction material in the USA for high-rise towers, industrial buildings, bridges and other structures. It competes with reinforced concrete in the US and rest of the world because of its many favorable characteristics including high strength, high stiffness, ductility and toughness, speed of erection, competitive cost, etc. Its use in the Middle East region has been mostly confined to industrial plants and warehouses. The rise in labor cost and the need for higher buildings will inevitably improve the competitive edge of steel in many instances in the near future.
-
COURSE OBJECTIVES
By the end of the course, you‘ll be able to :
- Be familiar with the “Steel Structure” design
- Understand the loads applied on the steel structure in oil, gas and petrochemical plant
- Know the modern technique on the risk-based inspection for maintenance plan
- Be familiar with the pipe rack design
- Know the design of the steel structure on machines
- Identify the use of composite section in strength and repair
-
How to deisgn piperack
-
To design the pipe rack for different loads like wind load
-
To designa steel deck under vibtrating loads
-
Full example to design crane tranck girder
-
Different between AISC and BS in design
-
How to design different steel members
-
COURSE AUDIENCE
This course is made for
- Design structural engineers
- Supervision engineer
- Planners
- Steel fabricator
- Construction engineers
-
COURSE OUTLINE
Day One
- Introduction
- The case for steel use in construction.
- Available steel grades and sections.
- Codes of practice for design, evolution from allowable stress to LRFD and limit state design.
- Design of tension members.
Day Two
- Design of compression members.
- Design of Beams
- Design of Beam-Columns
Day Three
- Bolted connections design
- Welded connections design
- Earthquake resistant design. New connection type.
- Fabrication and erection of steel instructor (Visiting Speaker)
Day Four
- Selection of structural systems for one story and multistory buildings.
- Rigidly connected frames
- Plane trusses
- Space trusses
- Bracing strategies and design
- Analysis of steel structures using computer packages
- Design of steel structures using computer packages
- Pre-engineered sections design (Visiting Speaker)
Day Five
- Design of composite beams.
- Design of built-up beams.
- Preparation of fabrication and erection shop-drawings
- Specifying structural steel
Keyword
Training Subject
Training Location
